This is the storyboard that we created for our movie opening sequence. On the piece of paper there are 18 boxes each side that equate to 36 overall. However after filling in several boxes, we realised that we didn't include spaces for the producers, distributors and film certification codes at the beginning.
When creating the storyboard we tried as hard as we could to make each and every shot unique, however we found out that this wasn't essential because after watching several film openings amidst the process of creating it was apparent that film makers often re-use the same camera angle/shot, so we replicated this instead.
After adding the finishing touches on the storyboard we then produced a shot list for each individual frame. This time we remembered to include the producers and distributors as shots on the list. Within the shot list we added multiple categories such as:
- Shot number
- Shot type/Camera angle
- Location of shot
- Minor description of shot
Learning Comment
From doing this task I have learned that draft storyboards shouldn't be too neat as they are not final (however in this case it was our final in the end). This was a mistake I made as I spent too much time doing some of the drawings on the sheet rather than thinking of any ideas for the upcoming shots. As a result of this our time to think about possible shots was shortened, which could harm the authenticity and quality of our film. On shot lists too there must be room for improvement, so everything initially must be written in pencil before pen.
No comments:
Post a Comment
Note: only a member of this blog may post a comment.